Configure Static IP Address on Solaris11

//Check current ip configuration status

# dladm show-phys
# ipadm show-if
# ipadm show-addr

//Check the interfaces name

# dladm show-phys

— output Example —
LINK MEDIA STATE SPEED DUPLEX DEVICE
net0 Ethernet up 1000 full e1000g0 –> Attentiom to this line
net1 Ethernet unknown 0 unknown pcn0

===============================================================================================

# ipadm create-ip net0

//Check status

# ipadm show-if

— output Example —
IFNAME CLASS STATE ACTIVE OVER
lo0 loopback ok yes —

net0 ip down no —

//Set IP static
— Template —

# ipadm create-addr -T static -a / /v4static

— Example —

# ipadm create-addr -T static -a 10.163.198.20/24 net0

===============================================================================================
//Check status

# ipadm show-if

— output Example —
IFNAME CLASS STATE ACTIVE OVER
lo0 loopback ok yes —

net0 ip ok yes —

//Check again

# ipadm show-addr

— Exmple —
ADDROBJ TYPE STATIC ADDR
lo0/v4 static ok 127.0.0.1/8
net0/v4 static ok 10.163.198.20/24
lo0/v6 static ok ::1/128

===============================================================================================
// add a persistent default route:

# route -p add default

— OR —

# route -p add

Leave a Comment